PMNS Permanent Magnetic Clamping Plates

Permanent magnetic clamping plates type PMNS are a special version of the highly accurate Pmnm. The switching point is at the top and the height has been reduced to a minimum of 35 mm. They are used where a flat and lightweight design is important, or where you cannot switch on the side of the device due to lack of space. The switching device is located recesssed in the top surface of the unit and protected against dirt. The low magnetic field prevents the magnetization level of the machining tools. The clamping plate is activated by a removable hex switch lever.

Concept:

Neodymium magnets, steel body,
Transverse pole 1.4 +0.5 mm
Nominal force 100 N / cm ²
Magnetic field height approx 5mm
Pole plate wearing limit 6mm

Recommendation:
High-precision, super-slim plate for grinding and for eroding